What size fence posts should i use

The number of these materials will vary depending on the length of the fence. Choosing the right type and measurement of wood for these materials are essential for your fence. The right type of wood to be used depends on your preferences. For the dimensions use the following instructions:.

The first thing you should do is to measure the perimeter of your fence and determine the amount of post that you will install. Bury a wooden stake at each corner of the fence and set the strings in these stakes for proper lining. Bury a wooden stake in between corners where you need to put a wooden post. Start digging on the spots where the wooden stakes are place.

Make sure that the hole is at least 2 feet in the ground. Bury the wood post and make sure that they are standing straight by using the carpentry level before covering the hole. Use concrete to cover the post holes for increased stability. You will also require a hammer, spirit level, long crowbar and shuv-holers.

If you are using a spiked post support system, you will also require a drive-in tool to avoid damaging the spikes. Clear the line of any old fence or undergrowth and peg the line. If there is a slope, work out the steps required.

If you are using post spikes, make a pilot hole with a bar. The drive-in tool protects the top of the spike and allows corrections but check regularly that it is driving square.

If you are digging in, keep the hole as small as practical: put mm of gravel or similar in the bottom of the hole, place the post in and use struts to hold the post in place and infill with Postmix. When spacing your posts, remember that the type of clip you intend to use will affect the gap required. Remember to check that the post is upright, square with the line and at the correct spacing.

Fill with post-mix to ground level. Ideally, the concrete should be sloping slightly away from the post. The post-mix will firm quite quickly: attach the panel to the first post and use this as a guide for the second post. Keep checking to ensure the posts are upright. The information and advice in this article is provided in good faith and is designed to give general information and guidance. Any reliance you place on such information is therefore strictly at your own risk.

If in doubt we strongly recommend you seek professional assistance. Delivery Information. This rule of thumb that can be followed for all size posts e. We do not recommend every post hole to be the same no matter the height of the fence post. We strongly recommend before you start digging your fence post hole that you either check for any mains electrics or contact your utility company to mark any underground cables or hazards.

Doing this also allows for you to reassess the fence line, layout and any positioning issues to make sure everything is exactly where you require it. This is to allow drainage to take place between the post and the concrete. For the best results we recommend using rapid drying Postcrete. Fence post spacing varies depending on how the fence will be used. Most posts that will carry an electric fence should be placed 12 to 20 feet apart.

When selecting a wooden fence post, there are a few things to consider. First off, remember that wooden fence posts will decay over time. This treatment slows the decay, often extending the life of a fence post from years to decades. Of course, not all CCA treated wood is the same.

Look for a measurement on the post that reads 0. This indicates the amount of CCA applied per cubic foot of lumber. Anything lower will break apart fairly quickly. The other consideration when selecting wood fence posts is the type of tree the post is derived from.